DentalPlant Adin CloseFit RP Compatible SmartPeg

Description

DentalPlant Adin CloseFit RP Compatible SmartPeg is a precision diagnostic component engineered to measure implant stability through resonance frequency analysis. Specifically designed for Adin CloseFit RP implants, this SmartPeg ensures accurate and reproducible ISQ values that aid clinicians in evaluating osseointegration and determining the right time for implant loading. Manufactured from lightweight anodized aluminum, it guarantees stability without altering the biological interface. Its secure threading provides a consistent fit, minimizing variability during readings. With a size configuration of M1.8 x 4.5 x 3.4 V90, it aligns perfectly with the implant system for reliable performance. Easy to attach and remove, this SmartPeg enhances workflow efficiency while supporting evidence-based decision-making in implant dentistry.

Key Features

• Engineered for Adin CloseFit RP implant system
• Provides consistent and reproducible ISQ values
• Constructed from lightweight anodized aluminum
• Ensures secure and stable connection during analysis
• Supports precise evaluation of osseointegration
• Facilitates evidence based clinical decisions
• Quick attachment and removal for workflow efficiency
• Optimized for use with resonance frequency analyzers

Specifications

• Compatibility: Adin CloseFit RP
• Thread Size: M1.8 x 0.35
• Length: 4.5 mm
• Height: 3.4 mm
• Angle: 90° V Type
• Material: Anodized Aluminum
• Compatible with DentalPlant Implant Stability Tester

Packaging

• 1 x DentalPlant Adin CloseFit RP Compatible SmartPeg

NOTE: Click here to buy Compatible DentalPlant Implant stability Tester

Directions for Use

Selection:

• Confirm that the implant is Adin CloseFit RP type before use
• Select the corresponding SmartPeg to match the implant connection precisely
• Ensure the SmartPeg is sterile and free from any visible damage

Preparation:

• Clean and dry the implant site for accurate measurement
• Verify calibration of the resonance frequency analyzer (RFA) device
• Keep the driver or tool ready for SmartPeg placement

Attachment:

• Insert the SmartPeg gently into the Adin CloseFit RP implant connection
• Tighten using finger pressure or the driver tool until secure
• Avoid applying excessive torque to prevent thread wear or distortion

Measurement:

• Position the RFA probe near the SmartPeg without direct contact
• Record ISQ (Implant Stability Quotient) values in multiple directions for reliability
• Interpret results according to clinical guidelines for implant stability and loading

Removal:

• Carefully unscrew the SmartPeg after completing ISQ measurements
• Clean and sterilize the SmartPeg following recommended protocol
• Store safely in its designated con

Additional Information

Warranty & Service

• Warranty is not applicable for this product