Piocreat NFEP Film For PioNext Ultra Dental 3D Printer (Pack of 5)

Description

This Piocreat NFEP release film is engineered specifically for the PioNext Ultra dental resin 3D printer, delivering low peel force that lifts cured layers cleanly off the vat floor. The reduced peeling stress means fewer failed prints, less delamination, and up to 30% faster print cycles for busy dental labs. Its high-clarity surface improves UV light transmission, so each layer cures evenly and holds fine detail with a smooth finish. Built for durability, the NFEP film resists damage, heat, and resin chemicals, staying dimensionally stable through long print sessions. Supplied as a convenient pack of 5, it keeps your printer running with ready replacements always on hand. Whether you print crown and bridge models, surgical guides, or aligner moulds, this film gives consistent, repeatable results with a higher success rate. A reliable upgrade for sharper output and faster turnaround on every dental print job.

Key Features

• Ultra-low peel force lifts cured layers cleanly and reduces print failures
• Enables up to 30% faster print cycles for higher lab throughput
• High-clarity NFEP surface improves UV transmission for even, detailed curing
• Heat and chemical resistant, staying stable through long print sessions
• Durable, damage-resistant build for extended service life

Specifications

• Film type: NFEP release film
• Compatibility: Piocreat PioNext Ultra dental resin 3D printer
• Pack quantity: 5 films
• Motor Speed; 1-100mm/s
• Thickness: 0.15mm
• Lenght: 28.5 cm
• Width: 20.5 cm
• Application: LCD/mSLA resin dental printing
• Property: Heat and chemical resistant

Packaging

• 5 x Piocreat NFEP Film For PioNext Ultra Dental 3D Printer.

Directions for Use

Preparation

• Power off the printer and remove the resin vat.
• Drain and clean the vat, then remove the old film and clamps.
• Wipe the frame clean and dry before fitting the new film.

Operation

• Place the NFEP film flat over the vat frame, keeping it centred and wrinkle-free.
• Tighten the frame evenly on all sides to maintain uniform tension.
• Refit the vat, refill resin, and run a test print to confirm clean release.

Post-Use Care

• Wipe the film gently with a soft cloth and isopropyl alcohol after each session.
• Inspect for cloudiness, punctures, or slack tension before each print.
• Replace the film once release quality drops or damage appears.

Warranty & Service

• Warranty is not applicable for this product.