Endoking Nanowarm Composite Warmer

Description

Endoking Nanowarm Composite Warmer is designed to heat the composite resin material, improve the flow performance of the adhesive, and can also be used as a manual device for heating bonding. AR Heat uses a precise circuit to control the heating module, so that the temperature tolerance is controlled at #1°C.
Depending on the choice of material and personal preference, temperature can be set up: 40 degrees, 45 degrees and 50 degrees.

Endoking Nanowarm Composite Warmer consists:

• Main body
• Power adapter
• Temperature indicator light
• Turn on/off button
• Thermopreferendum button
• Power DC socket

Key Features

• The temperature can be set according to choice of material and personal preference, ensuring optimal composite handling.
• Easy to use as both an automatic and manual device, offering flexibility in heating composite materials.
• Built to last, providing reliable and consistent performance over time.
• Helps achieve perfect bond strength and long-lasting composite restorations with the help of controlled heating.
• Warms local anesthetics for improved patient comfort and efficiency during dental procedures.
• Activates and enhances the efficacy of root canal irrigants, aiding in thorough and efficient root canal treatments.

Specifications

TECHNICAL SPECIFICATIONS:

• Output: 12V DC 3A
• Power: 36W
• Temperature setting: 40±0.5℃, 45±0.5℃, 50±0.5℃

PRECAUTION: The resin composite material must tighten the lid of the syringe, preventing leakage material within the heating body.

CLEAN and DISINFECT: All the parts can be cleaned with disinfectant using dish cloth. Don’t put any parts immersed in any liquid cleaning and disinfection, don’t disinfect under high temperature and high pressure

Fault warning: 3 sets of indicator light glisten together: Temperature sensor failure.

Packaging

• 1 x Endoking Nanowarm Composite Warmer
• 1 x Power adapter
• 1 x Instruction manual

Directions for Use

STEP 1: After connecting to 12V Direct Current, three indicator lights (red, green and blue) will be on. At that time, a composite heater can be used.

STEP 2: When users are using the heater, only the blue light indicator lighter will be flashing, means the heater is working at 40°C. If you need to turn it off, push ON/OFF button again, (at that time, three indicator lights will be on) and the heater will stop heating.

STEP 3: Three working modes ( 40°C/ 45°C/ 50°C) can be chosen by users, according to their requirements.

STEP 4: After choosing one working mode, (taking 40°C for example) the indicator light will keep flashing when the temperature is below 40°C. Otherwise, the light will keep lighting. At the same time, you can choose another heating mode. If without any action on it, the heater will be on standby after 30minutes.

STEP 5: If you need to use it again, just push ON/OFF button again and start heating.

STEP 6: The heater should be placed on smooth places.

Additional Information

• Country of Origin: Made in PRC

Warranty & Service

• 12 Months against Manufacturing Defect
  
• Physical Damage is not covered in any case
• Service and Warranty are handled by the manufacturer/importer directly for this product
• Dentalkart will not be liable to replace the Products and the liability to replace any such Product is that of the Manufacturer/Importer
• Dentalkart and the Buyer acknowledge that the Products purchased/used are a subject matter of original Manufacturer/Importer’s warranties only
• Any or all claims in relation to returns and replacement shall be made to the concerned Manufacturer/Importer only and Dentalkart may assist the customer in registering a request to get the Product replaced or serviced. 
• The Buyer acknowledges that the Products once sold will not be exchanged or taken back unless the seal of the package or the Product is intact or not altered in any manner or is not tampered as the case may be.