GC Gold Label II LC Capsules Pack Of 30 Shade – A2

Description

GC Gold Label II LC Capsule is a light-cured glass ionomer restorative with outstanding flexural strength and excellent bond strength to teeth even in presence of saliva. GC Gold Label II LC capsule’s exceptional aesthetics, simplicity and economy make it a fantastic choice for Class V restorations, cervical erosions/abfraction lesions and as a liner/base.

Indications:

• Class III and V restorations.
• Root surface caries and cervical erosion.
• Abfraction lesions.
• Lesions where cavity margins are in dentin or when enamel prisms cannot be properly etched.

Advantages:

• Smaller particles
• Excellent aesthetics and polishability
• Higher filler loading
• Significantly improved abrasion resistance
• Good radiopacity
• Facilitating post-operative diagnosis
• Self-adhesive to tooth structure
• No etching, no bonding
• Hydrophilic
• Very good results in areas where rubber dam is difficult to use, cavity margins are in dentin and enamel prisms can not be properly etched

Key Features

• Exceptional adhesive performance in Class V and Class III restorations.
• Up to 2 minutes manipulation time and immediate finishing after 20 seconds of light curing.
• Flowable consistency.
• Highest fluoride release.
• Ideal for caries stabilisation, deep lesions and endo-sealing.
• Clinically proven performance.
• Outstanding aesthetics, available in different VITA shades.

Specifications

• Powder / Liquid Ratio (g/g) – 0.33 / 0.10
• Mixing Time (sec.) – 10″
• Working Time (min. sec.) – 3’15”
• Light Curing Time (sec.) – 20″
• Depth of Cure (A2) (mm) – 1.8

Packaging

GC Gold Label II LC Capsules Pack Of 30 Shade – A2

• 1 x Powder (0.33g) per capsule
• 1 x Liquid (0.10g) per capsule

GC Gold Label II LC Capsules Pack Of 30 Shade – A3

• 1 x Powder (0.33g) per capsule
• 1 x Liquid (0.10g) per capsule

Directions for Use

• Shake the capsule or tap its side on a hard surface to loosen the powder 
• To activate the capsule, push the plunger until it is flush with main body
• Immediately place the capsule into a metal GC Capsule Applier and click the lever once.The capsule is now activated. Note : The capsule should be activated just before mixing and used immediately
• Immediately remove the capsule and set it into a mixer (an amalgamator) and mix for 10 seconds at high speed (+/-4,000 RPM) 
• Immediately remove the mixed capsule from the mixer and load it into the GC Capsule Applier
•  Make two clicks to prime the capsule then syringe
• Remove surface moisture but do not desiccate
• Extrude cement directly into preparation. Avoid air bubbles
• Form the contour and place a matrix if required
• Light-cure for 20 seconds using a suitable visible light curing device (470 nm wavelength)
• Finish under water spray using superfine diamond bur, silicone point and polishing strips

Additional Information

Country of Origin: Japan

Manufacturer:
GC Corporation
76-1 Hasunuma-cho, Itabashi-ku, Tokyo, Japan

Packer:
GC Corporation
76-1 Hasunuma-cho, Itabashi-ku, Tokyo, Japan

Imported By:
M/s GC India Dental Pvt. Ltd.
233, Phase III, IDA Pashamylaram, Patancheru, Sangareddy, Telangana – 502307, India
Phone: +91 72899 99456