Voco Ionofil Plus Refill Liquid 10ml

Description

Voco Ionofil Plus Refill Liquid 10ml

Key Features

• Spreadable and easy to work with.
• Good marginal adaptation for precise fitting.
• Continuous fluoride release for dental health.
• Translucent like natural enamel.
• Versatile for various dental applications.
• Suitable for all patient age groups.
• Professional use by trained dental practitioners.

Specifications

• Translucency: Similar to Enamel
• Setting Time: Approximately 2.5 min
• Working Time: Following Mixing: 2-3 min
• Mixing Ratio: 4.7-5.6 g Powder to 1 g Liquid
• Storage Instructions: Store at 4-23°C
• Tightly close powder and liquid container immediately after use.

Packaging

Refill Liquid 10ml Bottle

Directions for Use

Preparation:

• Ensure the operating site is dry when placing the filling, as glass ionomer cements are sensitive to moisture.
• If additional retention is required, undercuts can be utilized. The layer thickness of the fillings should not be less than 1 mm, and Class V cavities should be at least 1 mm deep.
• In cases of carious defects, prepare the cavity accordingly, clean it, rinse thoroughly with water, and dry the area. If there is approximately 1-1.5 mm of residual dentine thickness, no additional lining is necessary. For areas close to the pulp (less than approximately 1-1.5 mm), use pulp protection to prevent irritations.
• Shake the powder before use.
• Place the powder and liquid on a glass plate or a suitable mixing pad.
• Mix the powder and liquid in portions, starting with small amounts and working up to larger quantities. The recommended mix ratio is 4.7-5.6 g of powder to 1 g of liquid.
• Always hold the liquid bottle vertically when dispensing drops.
• Use a solid plastic spatula for mixing. The mixing time should not exceed 1 minute, typically lasting 30-40 seconds.
• The working time following mixing is approximately 2-3 minutes (at a temperature of 15-23°C).
• After introducing Ionofil Plus into the cavity, it will set within approximately 2.5 minutes.

Application:

• Ensure that the operating site remains dry during placement, as glass ionomer cements are sensitive to moisture, including breath and saliva during the setting phase.
• If possible, apply a protective varnish immediately to protect against moisture.
• After Ionofil Plus has set (typically 5-6 minutes after application, depending on mixing temperature and ratio), remove any excess material and perform finishing using flexible discs.
• Coat with varnish again.
• The best finishing results are typically achieved approximately 24 hours after placing the filling.

Additional Information

• Country Of Origin: Germany
• Manufacturer: Voco

Warranty & Service

• Warranty is not applicable for this product.