Ivoclar Variolink N Intro Pack

Description

Key Features

• Esthetic Excellence
• Dual-Cure and Light-Cure
• Material Compatibility
• High Radiopacity
• Customized Consistencies
• Shade Options
• Adhesive Cementation
• Versatile Applications
• Cavity Cleaning and Preparation Guidance
• Polymerization Control

Specifications

• Cool storage (2–8 °C/36–46 °F) is indicated for the Variolink N catalyst pastes
• Working time: About 3.5 min. at 37 °C/99 °F
• Mixing ratio: Mix base paste and catalyst in a 1:1 ratio.

Packaging

• 2 x 1.5g Syringes (Base transparent and Catalyst transparent/low viscosity)
• 1 x 5gm Monobond N
• 1 x 2.5gm Liquid Strip

Directions for Use

Removal of Temporary Restoration and Cleaning:

• Begin by removing any temporary restoration from the tooth cavity using appropriate dental instruments.
• Clean the cavity and the prepared tooth by removing any residue from the temporary luting composite. Use a polishing brush and an oil- and fluoride-free cleaning paste (e.g., Proxyt fluoride-free).
• Rinse the cleaned area with water.

Preparation of Restoration Surfaces:

• If you are working with composite or fiber-reinforced composite restorations, follow the manufacturer’s instructions for blasting the restoration surfaces.
• If necessary, clean the restoration in an ultrasonic unit for about 1 minute.
• Thoroughly rinse the restoration with a water spray and dry it with oil-free air.

Application of Primer Agent:

• Apply a primer agent (e.g., Monobond N or Monobond-S) to the pre-treated surfaces using a brush or micro brush.
• Allow the primer agent to react for 60 seconds.
• Disperse the excess primer agent using a strong stream of air. Ensure that the surfaces remain uncontaminated.

Pre-treatment of the Cavity (for enamel and dentin):

• To protect adjacent teeth and facilitate excess material removal, use a matrix band in the proximal regions.
• Apply N-Etch (37% phosphoric acid gel) to the prepared enamel and, if necessary, to the dentin. Follow the recommended etching times.
• Remove the etchant gel by rinsing it vigorously with water for at least 5 seconds.
• Ensure that the dentin surface remains slightly wet and shimmering (wet bonding). Remove excess moisture with appropriate methods, such as an air gun or dry brush.

Application of Variolink N:

• Depending on the type of restoration (inlays, onlays, crowns, veneers), follow the specific instructions provided in the Intro Pack.

Polymerization (Curing):

• Polymerize Variolink N segment by segment, starting with the proximal margins.
• Use a curing light with the appropriate light intensity as recommended by the manufacturer. Follow the recommended curing times based on the light source.

Finishing and Polishing of the Restoration:

• Use finishing and polishing strips in the proximal regions to achieve the desired finish.
• Check occlusion and function and make any necessary corrections.

Additional Information

Country of Origin: Liechtenstein

Manufacturer:
Ivoclar Vivadent AG
Bendererstrasse 2, 9494 Schaan, Liechtenstein

Packer:
Ivoclar Vivadent AG
Bendererstrasse 2, 9494 Schaan, Liechtenstein

Imported By:
Ivoclar Vivadent India Pvt. Ltd.
Ground Floor and 1st Floor, Khandsa Village, Gurugram, Haryana, India
Phone: +91 72899 99456

Warranty & Service

• Warranty is not applicable for this product.