GC G-Bond Refill

Description

Key Features

• Self-etching formula for efficient bonding.
• Designed for dental professionals’ precise application.
• Versatile bonding of composites and compomers.
• Contraindications for safe and targeted use.
• Avoids interference with eugenol and desensitizers.
• Simple application with disposable applicator.
• Quick and effective light-curing process.
• Storage flexibility: refrigerate for prolonged use.

Specifications

• Type: Self-etching light-cured adhesive
• Intended Users: Dental professionals
• Bonding Applications: Light-cured composites, compomers, dual-cured luting, and core build-up composites
• Compatibility: Not to be used with chemically cured resin, eugenol-containing materials, or desensitizers
• Application Method: Shake, dispense, apply with disposable applicator, air-dry
• Curing Time: 10-20 seconds depending on light source
• Storage: Refrigerate for prolonged periods; otherwise, store at room temperature

Packaging

• 1 x 5ml bottle

Directions for Use

Cavity Preparation:

• Prepare the tooth using standard techniques.
• Use a rubber dam for protection.
• Dry the prepared tooth surfaces by gently blowing with an air syringe.
• For direct pulp capping, use calcium hydroxide.

Application:

• Shake the G-BOND bottle thoroughly before dispensing.
• Dispense a few drops into a clean dispensing dish.
• Replace the bottle cap immediately after use.
• Apply G-BOND to the prepared enamel and dentin surfaces immediately using the Disposable Applicator II.
• Leave undisturbed for 5-10 seconds after the end of the application.
• Dry thoroughly for 5 seconds with oil-free air under maximum air pressure. Use vacuum suction to prevent adhesive splatter.

Additional Notes:

• When removing from the refrigerator after long-term storage, let the G-BOND bottle stand at room temperature for several minutes before use.
• Non-cut enamel should be treated with a 35-40% phosphoric acid gel, rinsed with water, and gently dried before using G-BOND.
• Apply G-BOND immediately, as the material contains a volatile solvent.
• Remove excess material on the tooth surfaces (other than those to be bonded) using a sponge or cotton pellet, as residue material is hard to remove after light curing.
• If the applied material is contaminated with water, blood, or saliva before light curing, wash and dry the tooth and repeat the application procedure.

Light Curing:

• Light cure using a visible light curing unit.
• Halogen/LED (700 mW/cm²): 20 seconds or 10 seconds if the light guide tip is more than 10mm away from the surface.
• High-power LED (more than 1200 mW/cm²): 10 seconds or 5 seconds if the light guide tip is more than 10mm away.
• Use a protective light shield or similar protective eyewear during light curing.

Placement of Composites:

• After light curing the adhesive, follow the manufacturer’s instructions to place, contour, and light cure the chosen composite resin material.

Finish and Polishing:

• Adjust the restoration and polish using standard techniques.

Additional Information

Country of Origin: Japan

Manufacturer:
GC Corporation
76-1 Hasunuma-cho, Itabashi-ku, Tokyo, Japan

Packer:
GC Corporation
76-1 Hasunuma-cho, Itabashi-ku, Tokyo, Japan

Imported By:
M/s GC India Dental Pvt. Ltd.
233, Phase III, IDA Pashamylaram, Patancheru, Sangareddy, Telangana – 502307, India
Phone: +91 72899 99456

Warranty & Service

• Warranty is not applicable for this product.