GC Tempron

Description

Tempron is a tooth colored temporary crown and bridge resin which is applied to the prepared areas of the tooth by placing it into the desired area of the impression which is reseated in the patient’s mouth.

INDICATION

• For the preparation of temporary crowns, bridges or dentures. Space maintenance.

Key Features

• Rapid cross linking
• Smooth surfaces without porosities
• Suitable for making repairs
• Comfortable working time

Specifications

Composition :

• Powder – Copolymer of Methylmethacrylate and Diethyl phthalate, Polymethylmethacrylate
• Liquid – Methyl methacrylate, N,N-dimethyl-p-toluidine

Packaging

• 1 x 100g Powder
• 1 x 104ml Liquid
• 1 x Powder Measure
• 1 x Liquid Measure No.4
• 1 x Mixing Cup

Directions for Use

A. CROWNS

1. PREPARATION

• a) Fill defects in the tooth with GC CAVITON or equivalent temporary filling material.
• b) Take an impression using a heavy (i.e. less water) alginate impression material. Wrap the impression in wet gauze to prevent distortion.
• c) Prepare the tooth to be crowned.
• d) Cut V notches in the impression from gingival to buccal and lingual sides to allow escape of excess resin.

2. MIXING

• a) The standard powder/liquid ratio is 1.0 g/0.5 mL (up to the first graduation on the powder measure and the first graduation of the liquid pipette).

Note: To minimize shrinkage use as little liquid as possible.

• b) Measure the liquid into the mixing jar, and slowly add the corresponding quantity of powder. Mix for 20-30 seconds.

3. APPLICATION

• a) Pour the creamy paste into the prepared impression, and seat tightly in the mouth.
• b) After 3 minutes in the mouth remove the impression, leaving the dough like resin on the tooth.
• c) Remove the resin crown before it is fully set and dip in and out of hot water (± 50°C) several times in order to prevent shrinkage.
• d) Trim any excess using a bur and then polish.
• e) Cement the temporary crown in position using GC FREEGENOL or other appropriate temporary cement.

B. BRIDGES

1. PREPARATION

• a) Select a suitable artificial tooth and fix between the abutment teeth using a suitable wax. Check the bite.
• b) Take a full arch impression using an alginate impression material. Carefully remove the pontic and wrap the impression in wet gauze.
• c) Prepare the abutment teeth as appropriate. Subsequent procedures are carried out as described above for crowns A. 1 (a) to A. 3 (e).

Additional Information

Country of Origin: Japan

Manufacturer:
GC Corporation
76-1 Hasunuma-cho, Itabashi-ku, Tokyo, Japan

Packer:
GC Corporation
76-1 Hasunuma-cho, Itabashi-ku, Tokyo, Japan

Imported By:
M/s GC India Dental Pvt. Ltd.
233, Phase III, IDA Pashamylaram, Patancheru, Sangareddy, Telangana – 502307, India
Phone: +91 72899 99456

Warranty & Service

• Warranty is not applicable for this product.