NewDiamond Zirconia Contouring & Finishing Diamond Bur Kit – Pack of 8 Burs

Description

The NewDiamond Zirconia Diamond FG Airotor Bur Kit is a specially engineered set of diamond-coated burs built to cut, section, and refine high-strength zirconia crowns and bridges. Zirconia is one of the hardest materials used in dentistry, and standard diamond burs dull quickly against it. This kit uses a durable diamond grit and reinforced bonding matrix that slices through zirconia cleanly while minimizing heat build-up, chipping, and micro-cracking of the restoration. Each bur features a Friction Grip (FG) shank that seats securely in any high-speed airotor handpiece, delivering smooth, controlled cutting at high rpm. The assortment includes multiple shapes and grits, letting clinicians move from rough sectioning to fine finishing without swapping instrument systems. Ideal for trimming crowns before cementation, adjusting occlusion and contacts chairside, or sectioning old zirconia crowns for removal, this kit is a reliable, long-lasting addition to any restorative or prosthodontic setup.

Key Features

• Diamond burs made specifically to cut and adjust hard zirconia
• 8-bur set: 4 shapes — Taper Flat (TF), Flame Ogival (FO), Ball Round (BR), Straight Fissure (SF)
• Each shape in standard grit (cutting) + fine “F” grit (finishing)
• Long-lasting diamond coating resists wear
• Cuts with less heat, chipping, and micro-cracking
• FG shank fits all high-speed airotor handpieces

Specifications

• Shapes: Taper Flat (TF), Flame Ogival (FO), Ball Round (BR), Straight Fissure (SF)
• Grits: Standard (cutting) + Fine “F” (finishing) for each shape
• Head length: TF & SF 7–8 mm · FO 4–5 mm · BR 2 mm
• Overall length: TF & SF 2.1 cm · FO & BR 1.9 cm
• Shank: FG (Friction Grip)
• Material: Diamond-coated stainless steel
• Application: Cutting & finishing zirconia crowns and bridge

Packaging

NewDiamond Zirconia Diamond FG Airotor Bur Kit

Directions for Use

• Select the appropriate bur for the step — TF or SF for straight cutting and reduction, BR for access and grooves, FO for margins and contouring.
• Sterilize the bur before use as per your clinic’s infection-control protocol.
• Insert the FG shank fully into a high-speed airotor handpiece until it locks.
• Operate at recommended high speed with continuous water-spray coolant to prevent heat build-up.
• Use the standard-grit burs first with light, intermittent pressure to cut and shape — let the diamond do the work.
• Switch to the matching fine “F” burs to smooth and finish the surface.
• Clean, inspect, and re-sterilize after use (single-patient use recommended).

Additional Information

Warranty & Service

• Warranty is not applicable for this product.