GC G-Aenial Anterior A1

Description

Key Features

• Optimised handling : With G-aenial anterior you gain total control over your results with its smooth, non-sticky and sculptable handling.
• Shade matching : With simple and easy to choose shades of G-aenial anterior, assures predictable value based aesthetics to your patients.
• High gloss finish : G-aenial anterior polishes quickly to a high gloss finish and the diverse filler surfaces within G-aenial ensure the surface really does shine! For best results, it is recommended to use diamond burs, polishing points and discs. To obtain a high gloss lustre, use GC DIA polishing paste in low speed for 15 minutes.
• Age aligned shade system : Enamel shade selection based on the age of the patient.
• More working time : Reduces stress with working time under ambient light extended to 4 minutes.
• Simplicity : even when complexity presents for most restorations, the use of standard shades alone is sufficient to produce beautiful, natural results.

Specifications

Irradiation Time 

• Plasma arc (2000mW/cm2) : 3 sec, 6 sec
  
• GC G-Light (1200mW/cm2) : 10 sec, 20 sec
• Halogen / LED (700mW/cm2) : 20 sec, 40 sec

Note : Depth of curing will vary according to the timings selected for curing composite.

Packaging

Syringe A1

Directions for Use

• Shade Selection : Clean the tooth with pumice and water. Shade selection should be made prior to isolation. Select the appropriate G-ænial shades by referring to the G-ænial shade guide.
• Cavity Preparation : Prepare cavity using standard techniques. Dry by gently blowing with oil free air. Note : For pulp capping, use calcium hydroxide.
• Bonding Treatment : For bonding G-ænial to enamel and / or dentin, use a light-cured bonding system such as GC G-ænial Bond, GC G-BOND, GC Fuji BOND LC or GC UniFil Bond.
• Placement of G-ænial : Remove syringe cap and dispense material onto a mixing pad. Place the material into the cavity using a suitable placement instrument. After dispensing, screw syringe plunger anticlockwise by a half to full turn to release residual pressure inside the syringe. Replace cap immediately after use.
• Contouring before Light Curing : Contour using standard techniques.
• Light Curing : Light cure G-ænial using a light curing unit. Keep light guide as close as possible to the surface.
• Note :
  1. Basically, material can be applied in a single layer to achieve aesthetic restorations using Standard shades.
  2. Material may be hard to extrude immediately after removing from cold storage. Prior to use, leave to stand for a few minutes at normal room temperature.
  3. After dispensing, avoid too long exposure to ambient light. Ambient light can shorten the manipulation time

Additional Information

Country of Origin: Japan

Manufacturer:
GC Corporation
76-1 Hasunuma-cho, Itabashi-ku, Tokyo, Japan

Packer:
GC Corporation
76-1 Hasunuma-cho, Itabashi-ku, Tokyo, Japan

Imported By:
M/s GC India Dental Pvt. Ltd.
233, Phase III, IDA Pashamylaram, Patancheru, Sangareddy, Telangana – 502307, India
Phone: +91 72899 99456

Warranty & Service

• Warranty is not applicable for this product